• Less heat and noise in the refrigeration area: By separating the evaporator unit and the condenser unit, heat and noise from the condenser unit are relocated outside.
• Suitable for low ceiling heights: Compared to ceiling units, the split unit requires less space above the cold room for ventilation.
• More storage space inside the cold room: Compared to wall units, there is more room inside for the installation of storage shelving.

• Split refrigeration unit consisting of 1 outdoor unit & 1 indoor unit
• For a maximum 19.8 m³ cold storage room
• Temperature range: -5 °C to +8 °C
• Digital display on the condenser
• Evaporator as Cu/Al finned heat exchanger
• Automatic defrost with programmable intervals and duration
• Condensate drain to the outside
• Door contact switch & cold room light each with 2.5 m cable

Quiet and space-saving cooling

Split refrigeration units are a practical solution for walk-in cold rooms in gastronomy, commercial kitchens, and food businesses. Evaporator and outdoor unit arranged separately, the heat and noise from the compressor are directed outside or into a technical room. This ensures a more pleasant working environment and supports the energy efficiency of the unit. The flat evaporator on the ceiling additionally creates more space for storage. An integrated digital thermostat facilitates the precise setting of the desired temperature. This allows flexible cooling adjustment for rooms with low ceilings or limited ventilation.

• ⚠️ A qualified refrigeration technician is required to extend the supplied refrigerant lines and to refill the refrigerant.
• ⚠️ For adequate ventilation and efficient operation, we recommend leaving 400 mm of space on each side, as well as above and below.
• Due to the IP 23 protection class, we recommend installation indoors or in a weather-protected, covered outdoor area.

• We recommend regularly checking the evaporator for dirt and icing and carefully cleaning it if necessary. This ensures optimal air circulation and reliable cooling performance.
• For the condenser unit, care should be taken to ensure that the ventilation slots are not covered, to guarantee optimal heat dissipation and efficient operation.