• Less heat and noise inside: By mounting the evaporator unit and condenser unit separately, heat and noise from the condenser unit are relocated outside.
• Suitable for low ceiling heights: Compared to ceiling units, less space is required above the cold room for ventilation.
• More space for storage shelves: Compared to wall units, there is more room inside for the installation of storage shelves.

• Split refrigeration unit consisting of 1 outdoor unit & 1 indoor unit
• For a maximum of 11.1 m³ cold storage room
• Temperature range: -5 °C to +8 °C
• Digital display on the condenser
• Evaporator as Cu/Al finned heat exchanger
• Automatic defrosting with programmable intervals and duration
• Condensate drain to the outside
• Door contact switch & cold room light each with 2.5 m cable

Quiet operation for cold rooms

Split refrigeration units are a practical solution for walk-in cold rooms in gastronomy, large kitchens, and food businesses. By separating the evaporator and outdoor unit, the heat and noise from the compressor are directed outside or into a technical room. This ensures a more pleasant working environment while also supporting the energy efficiency of the unit. The flat evaporator with ceiling mounting saves space in the cold room, leaving more room for storage. An integrated digital thermostat facilitates precise temperature adjustment. The system can also be flexibly installed and is suitable for rooms with low ceilings or limited ventilation.

• ⚠️ An accredited refrigeration technician is required for the extension of the supplied refrigeration lines as well as for refilling the refrigerant.
• ⚠️ To ensure adequate ventilation and efficient operation, we recommend leaving a clearance of 400 mm on each side as well as above and below.
• ⚠️ Due to the IP 23 protection rating, we recommend installation indoors or in a weather-protected, covered outdoor area.

• We recommend regularly checking the evaporator for dirt and icing and carefully cleaning it if necessary. This ensures optimal air circulation and reliable cooling performance.
• For the condenser unit, care should be taken to ensure that the ventilation slots are not covered, to guarantee optimal heat dissipation and efficient operation.